• Sizes: ISO, Mini, 8mm & 9.4mm
  • Field wireable
  • Fully molded
  • NEMA rated
  • Optional indicator lights
  • Surge suppression
  • Full-wave bridge rectified
  • Custom wire lengths

Solenoid Valve DIN Connectors and Accessories

Cost-effective solenoid valve connectors that offer
performance, durability, and
quality components.

  • Home •
  • Field Wire DIN 43650 Solenoid Valve Connectors

Field Wire DIN 43650 Solenoid Valve Connectors

5000 - standard hardwired

5000 - Standard Hardwired

The ISO and 8mm Sub-Micro connectors are made according to DIN 43650 / ISO 4400, EN175301-803:2000. The MINI and 9.4mm Sub-Micro connectors are industry standards. All are used as protective enclosures for electrical connection in conjunction with hydraulic and pneumatic solenoid valves. These connectors offer distinct advantages over "hardwired" solenoid valves because of their modular design. Used where rapid installation and service are a must. Better than molded construction when special wire is needed or when using one long wire run.

Documents

P5600 - surge suppression

P5600 - Surge Suppression

The Micro Protective Connectors are available in standard MINI, DIN 43650 Form "A" / ISO 4400, EN175301-803:2000 and Sub-Micro 8mm and 9.4mm. The Canfield Connector MPCs provide electrical controllers surge suppression against voltage spikes caused by the solenoids used on hydraulic and pneumatic solenoid valves.

Documents

R5000 - full wave bridge rectifier

R5000 - Full Wave Bridge Rectifier

Canfield Connector's R5000 Series solenoid valve connectors incorporate full-wave bridge rectifiers inside the DIN 43650 Form "A" / ISO 4400, EN175301-803:2000 connectors. This standard permits industry interchange-ability and has been embraced by the solenoid valve industry worldwide. The R5000 converts alternating current to direct current reducing coil burnout due to valve sticking. Also, direct current eliminates AC "hum" inherent to alternating current. Features include the ability for the user to wire the connector into existing installations. Wire connections are made inside the connector housing and the wire inlet is either PG9 strain relief, 3/8" or 1/2" conduit. The R5000 has a maximum current rating of 1 Amp continuous with maximum wire gauge diameter of 14 AWG. An indicator light is offered for instant diagnostics and to aid setup and installation.

Documents