• Sizes: ISO, Mini, 8mm & 9.4mm
  • Field wireable
  • Fully molded
  • NEMA rated
  • Optional indicator lights
  • Surge suppression
  • Full-wave bridge rectified
  • Custom wire lengths

Solenoid Valve DIN Connectors and Accessories

Cost-effective solenoid valve connectors that offer
performance, durability, and
quality components.

  • Home •
  • Male DIN 43650 Solenoid Valve Connectors & Accessories

Male DIN 43650 Solenoid Valve Connectors & Accessories

DCP - DIN coil pin protectors

DCP - DIN Coil Pin Protectors

The Canfield Connector DCP coil pin protectors are low cost replacements for solenoid connectors that ensure protection of solenoid terminals during shipping and handling. They can also be used to protect spade style terminals on a variety of other products. DCPs are available in a host of colors and styles as well as special logo markings to match the application. Constructed of low cost yet rugged polymers, the DCP adds aesthetic appeal and advertising value to the solenoid valve. There is a DCP available for ISO, industry standard MINI, Sub-Micro, and dual spade hydraulic coils.

Documents

iLW - interposed lighted wafer indicator light

iLW - Interposed Lighted Wafer Indicator Light

The Canfield Connector Interposed Lighted Wafer is an electronic, state of the art lighting module designed to install between a DIN type coil and the mating connector. Utilizing SMT (Surface Mount Technology), the iLW's ultra-thin design and high luminescence Gallium Arsenide LEDs enable the lighted wafer to retrofit existing applications or to be used in conjunction with unlighted connectors. Designed to "sandwich" between the connector and the coil, the iLW seals from dust and moisture. The iLW can be installed several times without degradation of the contact surfaces and is not polarity dependent.

Documents

M5 - male quick disconnect interfaces

M5 - Male Quick Disconnect Interfaces

Canfield Connector male connectors are used as electrical quick disconnect interfaces for pneumatic and hydraulic valves and sensors. They are available in standard MINI, DIN 43650 Form "A" / ISO 4400, EN175301-803:2000, Sub-Micro 8mm, 9.4mm, and conduit arrangements. Some male connectors are available with 2+ ground or 3+ ground terminal options.

Documents

MCCR - multiple control distribution

MCCR - Multiple Control Distribution

The Canfield Connector MCCR is a cable distribution connector which uses pass-through technology to allow control of multiple parallel or independent devices. Devised with double solenoids and solenoid valve manifolds in mind, the MCCR allows for simplified wiring and easy replacement of components in an automated, modular environment. The gasket-thin head fits between a single female connector and the associated male device with the DIN 43650 Form "A", EN175301-803:2000 interface. Exiting from the MCCR head is a three conductor cable with ISO HT PG9 strain relief connector attached. Two available circuits allow for separate (independent) or parallel (simultaneous) control of the downstream device. The environment resistant quick connect style allows for plug and play designs in the factory that require modern hydraulic or pneumatic systems.

Documents